DieHard 71341 Bedienungshandbuch Seite 9

  • Herunterladen
  • Zu meinen Handbüchern hinzufügen
  • Drucken
  • Seite
    / 10
  • Inhaltsverzeichnis
  • LESEZEICHEN
  • Bewertet. / 5. Basierend auf Kundenbewertungen
Seitenansicht 8
9
MAINTAINING A BATTERY
The 28.71341 charges and maintains
6 and 12 volt batteries, keeping them at
full charge.
NOTE: The maintain mode technology
allows you to safely charge and maintain
a healthy battery for extended periods of
time. However, problems with the battery,
electrical problems in the vehicle, improper
connections or other unanticipated
conditions could cause excessive current
draws. As such, occasionally monitoring your
battery and the charging process is required.
FAN OPERATION
It is normal for the fan to be on all the
time. Keep the area near the charger
clear of obstructions to allow the fan to
operate efciently.
BATTERY CHARGING TIMES
CCA = Cold Cranking Amps RC = Reserve Capacity Ah = Amp Hour
BATTERY SIZE/RATING
CHARGE RATE/TIME
6A<>2A
SMALL BATTERIES
Motorcycle, garden tractor, etc.
6-12 Ah 1½-2½ h
12-32 Ah 2½-7 h
CARS AND TRUCKS
200-315 CCA 40-60 RC 7½-9½ h
315-550 CCA 60-85 RC 9½-12 h
550-1000 CCA 85-190 RC 12-23 h
MARINE/DEEP-CYCLE
80 RC 12 h
140 RC 18 h
160 RC 20 h
180 RC 22 h
Times are based on a 50% discharged battery and may change, depending on age
and condition of battery.
12. MAINTENANCE AND CARE
A minimal amount of care can keep your
battery charger working properly for years.
•Clean the clamps each time you are
nished charging. Wipe off any battery
uid that may have come in contact with
the clamps to prevent corrosion.
•Occasionally cleaning the case of the
charger with a soft cloth will keep the
nish shiny and help prevent corrosion.
•Coil the input and output cords neatly
when storing the charger. This will help
prevent accidental damage to the cords
and charger.
•Store the charger unplugged from the AC
power outlet in an upright position.
•Store inside, in a cool, dry place. Store
the clamps on their support posts, to
ensure they do not come into contact
with any metallic surface.
13. TROUBLESHOOTING AND ERROR CODES
Error Codes
ERROR
CODE
DESCRIPTION REASON/SOLUTION
F01
The battery voltage is still under
10V (for a 12V battery) or 5V
(for a 6V battery) after 2 hours of
charging.
The battery could be bad. Have it checked or
replaced.
F02
The charger cannot desulfate the
battery.
The battery could not be desulfated; have it
checked or replaced.
F03
The battery was unable to reach
the “full charge” voltage.
May be caused by trying to charge a large battery or
bank of batteries on too low of a current setting. Try
again with a higher current setting or have the battery
checked or replaced.
F04
The connections to the battery
are reversed.
The battery is connected backwards. Unplug the
charger and reverse the connections to the battery.
F05
The charger was unable to
keep the battery fully charged in
maintain mode.
The battery won’t hold a charge. May be caused
by a drain on the battery or the battery could be
bad. Make sure there are no loads on the battery. If
there are remove them. If there are none, have the
battery checked or replaced.
Seitenansicht 8
1 2 3 4 5 6 7 8 9 10

Kommentare zu diesen Handbüchern

Keine Kommentare